Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Oldcastle Kitchen Remodeling: The Orlando Owner’s Guide
Oldcastle kitchen remodeling in Orlando typically runs $14,000 – $45,000 depending on the cabinet line, countertop material, and whether you’re doing a full gut or a refresh. Most homeowners call us because their Oldcastle kitchen cabinets or countertops are showing real failure: delaminating veneer, swollen cabinet bases from Florida humidity, or countertop seams that have cracked and started collecting water. The good news is we match Oldcastle-spec materials and hardware, and we can usually get your kitchen measured and priced within a week of the first call.
What surprises most Orlando homeowners is how the failure shows up quietly. You don’t notice the cabinet box pulling away from the wall on day one. You notice it three months later when the drawer starts dragging, then sticking, then the corner of the face frame separates just enough to catch the light. By the time you’re searching for Oldcastle kitchen remodeling, the part has usually been failing for a while. That’s normal. It’s also fixable.
We’re an independent remodeling contractor in Orlando, not affiliated with Oldcastle. What that means for you: we work on Oldcastle-spec kitchens every month, we know which components fail in Central Florida’s climate, and we don’t have to route your project through a corporate parts desk. We order the right parts, show up when we said we would, and put the price in writing before anyone touches a cabinet.
Which Oldcastle Models This Applies To
Oldcastle kitchen components show up across a range of cabinet lines and countertop materials. The big gotcha we see in Orlando homes is a cabinet hinge and drawer-slide mismatch: some Oldcastle-spec cabinets shipped with 35mm European cup hinges (Blum-style), while others used face-frame hinges with different overlay measurements (usually 1/2″ or 1-1/4″). If you order the wrong hinge style, the door will never sit flush no matter how many times you adjust it. Before we order anything, we pull a drawer or remove a door in your kitchen to confirm the hinge pattern and slide length.
Countertops are a similar story. Oldcastle-spec kitchens in Florida commonly use quartz or solid-surface materials with specific seam tolerances. If a seam has failed, we need to know the slab thickness (typically 2cm or 3cm) before we can spec a repair or replacement piece. For OEM Oldcastle parts, we order through established supplier channels and verify the SKU against your cabinet box stamp or the label inside a drawer. For quality aftermarket equivalents, we stick with brands we’ve installed for years: KraftMaid and Wellborn cabinetry, and Cambria or Silestone countertops when a full replacement makes more sense than a patch.
Here’s the honest version: for hardware and cabinet components, OEM is usually worth the slight premium because the tolerances match what you already have. For countertops and tile, a quality aftermarket material often outperforms the original at the same or lower price. We’ll show you both numbers and let you decide.
Styles & brands we work with
Signs Your Oldcastle Kitchen Remodeling Is Failing
- Drawer fronts sagging or rubbing against the cabinet frame. This usually means the drawer slide has lost its grip on softened cabinet material. Florida humidity swells MDF drawer boxes over time, and the screws that hold the slide start to wallow out. You’ll see the drawer slow down, then catch on one side.
- Cabinet doors that won’t stay closed or sit crooked. The hinge plate has usually loosened, or the hinge itself is worn past adjustment. On Oldcastle-spec face-frame cabinets, this is often the 1/2″ overlay hinge with a stripped mounting screw. Tightening it helps for a week, then it sags again.
- Laminate or veneer peeling at the bottom edges of base cabinets. This is the classic Orlando kitchen failure. A small under-sink leak or years of mopping water against the toe kick wicks up into the cabinet box, and the laminate lets go. By the time you see peeling, the substrate behind it is usually swollen.
- Countertop seams separating or staining along the joint. Quartz and solid surface move slightly with temperature swings, and a seam that wasn’t bonded correctly will open up and trap coffee, wine, or sink water. You’ll see a dark line that won’t clean off, and sometimes a slight lip from one slab to the other.
- Soft-close hinges or slides that slam hard now. The damper inside the hinge or slide has failed. On Oldcastle-spec kitchens with soft-close throughout, you usually lose one or two first, then the rest follow within a year. It’s a small part, but it makes the whole kitchen feel worn out.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Orlando, a full Oldcastle kitchen remodel typically lands between $14,000 and $45,000. A smaller kitchen refresh where we’re replacing cabinet doors, drawer fronts, hardware, and a backsplash runs $9,000 – $20,000. Cabinet installation alone sits at $4,000 – $13,000, and countertop installation at $2,000 – $6,500 depending on the slab material and square footage. Backsplash work adds $800 – $2,500.
What drives the number up or down? Cabinet line is the biggest lever. Refacing with quality doors costs less than full replacement with KraftMaid or Wellborn boxes. Countertop choice matters too: Cambria quartz runs higher than standard solid surface. Layout changes, electrical work, or moving a sink or range will push the price toward the top of the range.
Every job includes a written price before we start, so there’s no door-knock surprise after demo day. The labor is covered under our 365-Day Done Right Promise: if something fails within a year, we come back and fix it at no charge. Materials carry their own warranties on top of that, so you’re not relying on a single layer of protection.
DIY or Call Us?
You can safely replace cabinet hardware, touch up paint on a face frame, or adjust a hinge that’s simply loose. That’s straightforward. What gets owners in trouble is pulling a failed cabinet box apart, attempting a countertop seam repair, or rebuilding a drawer box without knowing the material and slide spec. We’ve fixed enough DIY attempts in College Park bungalows to know that a $40 hinge order becomes a $400 fix when the wrong part chews up the cabinet.
If the failure is structural, swollen, or involves a seam that’s taking on water, call us. We’ll come out, identify exactly what failed, and hand you a written price for the fix or the full remodel. No pressure, no open-ended quote. Call (850) 427-6454 and we’ll set up a time to look at it.
FAQs
With proper ventilation and no water intrusion, Oldcastle-spec cabinets should last 15 – 25 years in Orlando’s humidity. The failures we see most often are climate-related: swollen MDF from moisture, hinge wear from doors that get bumped in tight kitchens, and finish breakdown from constant humidity cycling. Call (850) 427-6454 if your cabinets are failing early; we’ll tell you honestly whether it’s a repair or a replacement situation.
Yes, in most cases a partial repair is cheaper and faster than a full remodel. We rebuild drawer boxes, replace hinges and slides, re-bond countertop seams, and reface cabinet fronts without pulling everything out. The line is drawn when the cabinet boxes themselves are swollen or water-damaged; at that point you’re throwing money at a structure that’s already compromised. We’ll show you both the repair price and the replacement price and let you decide.
A cabinet and countertop-focused remodel typically takes 2 – 5 weeks depending on material lead times and whether we’re moving plumbing or electrical. Cabinet refacing with new doors and hardware can be done in 1 – 2 weeks since the boxes stay in place. We give you a written schedule with your written price, and we stick to the arrival window we set.
We stock common Oldcastle-compatible hardware on our trucks: 35mm European hinges, face-frame overlay hinges, soft-close slides, and drawer glide replacements. For cabinet doors, drawer fronts, and countertop slabs, we order to spec after measuring your kitchen. Most parts arrive within 5 – 10 business days. Call (850) 427-6454 and we’ll tell you whether the part you need is something we can grab same-day or order in.
Written by Trevor Nash, Owner, Penhallow Remodeling Orlando at Penhallow Remodeling Orlando, serving Orlando and nearby areas.
