







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Ameristar Roofing: The Orlando Owner’s Guide
If your Ameristar roof is leaking, lifting, or showing rust streaks after a storm, the fix usually comes down to a failed part: a cracked pipe boot, a corroded flashing seam, or a torn section of underlayment under the shingle or panel. We stock Ameristar-compatible roofing components in Orlando and typically install repairs for $400 – $1,800 depending on what failed and how much of the roof surface has to come apart to reach it. Most owners discover the problem the same way: a water stain on the ceiling after an afternoon thunderstorm, or a shingle tab in the yard after a windy night.

Penhallow Remodeling Orlando is an independent service provider, not affiliated with Ameristar. We work on their roofing systems because Orlando homeowners keep asking us to, and because the parts are straightforward to source when you know which series you’re dealing with.
Which Ameristar Models This Applies To

Ameristar makes two roofing lines that show up regularly on Orlando homes: asphalt shingle systems (their standard architectural shingle, sold through roofing supply houses across central Florida) and a metal panel line used on carports, patio covers, and some residential roofs. The parts are not interchangeable between the two. A shingle roof uses felt or synthetic underlayment, step flashing, pipe boots, and ridge cap shingles. A metal roof uses panel clips, closure strips, and a different flashing profile altogether. If you buy a pipe boot meant for an asphalt roof and try to seal it to a metal panel, you’ll chase the leak for months.
The fastest way to identify what you have: check the permit paperwork from the original install, or look at the roof edge. Ameristar architectural shingles have a distinctive square tab pattern with a heavier granule coating than builder-grade shingles. Their metal panels are typically 26-gauge or 29-gauge, in 3-foot widths, with a rib profile that matches several generic brands. For metal, measure the rib spacing before ordering any replacement panel: Ameristar panels come in 9-inch and 12-inch rib centers depending on the series, and that measurement determines whether an aftermarket panel will actually interlock. For shingles, the underlayment matters more than the shingle itself: Florida code requires a secondary water barrier under shingles since 2007, and that’s usually what fails first on an older Orlando roof.
OEM versus aftermarket: Ameristar shingles sold today are the same product regardless of the distributor label, but there is a meaningful difference in underlayment quality. We use synthetic underlayment rated for high-temperature exposure rather than the felt paper some supply houses still stock, because Orlando attic temperatures in August will cook felt to the point of brittleness within a decade. For metal roofs, we recommend sticking with Ameristar-spec panels when the roof is under 10 years old, just to keep the color and rib profile matched. Older than that, an aftermarket panel in a close color match usually makes more financial sense than replacing the entire roof.
Styles & brands we work with







Signs Your Ameristar Roofing Is Failing
- Water staining on the ceiling after rain. This is almost always flashing around a pipe, valley, or wall intersection. The shingle or panel above it may look perfectly fine, which is why roof leaks fool so many homeowners into replacing the wrong thing.
- Shingle tabs in the yard after a storm. Ameristar shingles have a strong adhesive strip, but once the seal breaks from age or a hard wind, the tab becomes a sail. If you’re finding tabs after every summer storm, the shingle field is losing its bond and repair options get narrower.
- Rust streaks or corrosion on metal panels. Florida’s humidity and salt air will eat through exposed fastener heads and panel edges faster than the panel itself. The streaks are usually cosmetic at first, but corroded fasteners are the first thing to fail structurally on an Ameristar metal roof.
- Granules in the gutter or at the downspout. Shingle granules protect the asphalt layer from UV. Once they start washing off in volume, the shingle is past the halfway point of its life. On a 15-year-old Ameristar roof in Orlando, this is normal. On a 7-year-old roof, it means the original install may have used a lower-grade shingle than the paperwork said.
- Daylight visible through the attic boards. A few pinholes are normal around old nail penetrations. Wide gaps or cracks along plywood seams mean the decking is failing from moisture, and that’s a structural repair, not a roofing patch.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Orlando roof repairs on Ameristar systems run $400 – $1,800 installed. The low end covers small, accessible fixes: a single pipe boot, a short section of step flashing, a few shingle tabs replaced. The high end accounts for work like removing and resetting a valley, replacing multiple panels on a metal roof, or cutting out a section of rotted decking and rebuilding it before the new underlayment goes down.
| Repair Type | Typical Orlando Installed Price |
|---|---|
| Pipe boot replacement (asphalt shingle roof) | $400 – $750 |
| Step flashing repair at wall or chimney | $500 – $1,100 |
| Underlayment patch (remove and reset shingles) | $700 – $1,400 |
| Metal panel replacement, single panel | $600 – $1,200 |
| Rotted decking section replacement (per 4×8 sheet) | $300 – $500 added to repair |
What drives the price: how much of the roof surface has to come apart to reach the failed part, whether the decking underneath is sound, and whether we’re matching Ameristar-spec components or an aftermarket equivalent. On a repair, you get a written price before any work starts, and the line items spell out parts and labor separately. That’s the Penhallow way for every job, including roofing. If the repair fails inside 365 days, we come back and fix it at no charge. That’s in writing, not a verbal promise.
DIY or Call Us?
There’s one thing worth checking yourself before you pick up the phone: look at the roof from the ground after a storm. Missing tabs, lifted flashing, a pipe boot cracked at the base. If you spot something obvious, take a photo. That photo helps us give you a tighter estimate on the first call.
We don’t recommend getting on an Orlando roof for any repair, and the reason is simple: most roof injuries happen during the walk, not the work. Steep pitches, brittle shingles on a hot afternoon, and wet algae patches after rain make the surface unpredictable. What’s more, a homeowner’s repair that misses the real issue, like re-sealing a pipe boot when the underlayment underneath is already wicking water, just buys you a bigger leak in a few months. For anything beyond a visual inspection from the ground, call us at (850) 427-6454. We’ll look at the roof, tell you what failed, and give you the number before anyone picks up a tool.
FAQs

An Ameristar architectural shingle roof typically lasts 15 – 20 years in Orlando’s sun and storm cycle, while metal panels can go 30 – 40 years if the fasteners and flashing are maintained. The underlayment usually fails before the shingle surface does, which is why a 15-year-old roof can look fine from the street and leak anyway. Call (850) 427-6454 and we’ll tell you what you’ve got left up there.
Repairs make sense when the failure is isolated to flashing, a pipe boot, or a few shingle tabs, and when the surrounding roof is under 15 years old. If the decking is soft across multiple sheets or the shingle field is losing granules across the whole slope, patching becomes throwing good money after bad. We’ll tell you which one you have, straight.
Most repairs are done in a single visit, typically 2 – 4 hours on site. Larger underlayment or decking repairs can run a full day. Either way, you’ll know the timeframe before we start, and the price is the same on the invoice as it was on the written quote. Call (850) 427-6454 to schedule a look.
We keep common Ameristar-compatible parts on the truck: pipe boots, step flashing, cap shingles, fasteners, and a small stock of metal panel profiles in standard Orlando colors. If your roof needs something less common, we source it from our supply house, usually within a day or two. For a free estimate on an Ameristar roof repair in Orlando, call (850) 427-6454.
If you’re planning work that goes beyond repairing your roof, we also install KraftMaid and Cambria cabinetry and Silestone countertops, so the same crew that fixed your roof can handle the kitchen when you’re ready.
Written by Trevor Nash, Owner, Penhallow Remodeling Orlando at Penhallow Remodeling Orlando, serving Orlando and nearby areas.


